What exactly is the difference between a surge protector and a fuse? Can a fuse protect the electronic devices from lightning instead of surge protector?
08.06.2025 14:03

But… the neutral is now “floating” because of the 1 ohm resistance.
“ A surge suppressor is the one which is connected at the input supply so that when there is a sudden change voltage it bypasses thereby protecting the (circuit) and electronic components”
Here is a simplified AC power diagram.
What have you learned from your parents' mistakes?
what exactly is a ‘surge’ protector?
The other is “what does a “fuse” do?”
(Dc diagram shown, AC is similar).
Packers waive receiver, open up roster spot - Acme Packing Company
If the nominal power is 4,000 watts then the current at 230volts is 16 amps.
Edit 2024–10.
2024–10–00 [ Ammar Mahdi ] Ammar Mahdi
What is the most inappropriate thing your wife has done in front of you?
But during the surge, the fuse will not blow if it is a longer duration and lower value )10 to 50%).
There are three different concepts here that are getting confused.
One is “what exactly is in a ‘surge protector’ ? ”
Texas woman dies from brain-eating amoeba after clearing sinuses with tap water - Dallas News
So, it’s possible that these devices from Trip Lite have addition suppression devices, these ones seem to be sturdy.
First Sentence:
He then describes the function of a fuse.
Because the load is inductive, the current lags the voltage.(by a bit).
“ A fuse is a device which protects the (circuit) against overload and short circuit.”
So, the voltage could go up to 500 volts, and the fuse will not open up.
Upvotes:
The MOV will conduct when the voltage exceeds 50% of line voltage.
When the current is 200% of the rated value , it will “go open” (the link metal melts) and protect the device.
He then asserts :
The bolt then partially travels down the line to your home.
P = e* I, so since I is 16 amps, then the voltage dropped is 1/16 volt or 0.0650 volts.
This is an electronic circuit designed to clamp voltages so that the Voltage Potential that appears at the outlet is never going to exceed the nominal value.
“ … to protect building, lightning arrestor, is provided above building and directly connected to earth.”
Once the voltage goes over 0.0650 volts, then this fact can be used to amplify the difference, and turn the circuit breaker off , furthur down the line. Essentially that is what a RCD/GFCI does, it compares the incoming current, to the outgoing current, and if the difference between the two currents is over 5mA, then it trips the circuit breaker.
Why doesn’t Melania Trump do some more modeling?
It seems Mohan does not understand the difference between a comment and an Answer.
Would individual surge supressors have save this equipment? most likely, since the surge supressor would take the jolt instead of the electronic components.
There are two important concepts here.
eight
the problem then depends on "how fast does the fuse operate?".
This is a high voltage low current spike that comes down the line because of the power poles being struck, and the voltage suppressors activating on the primary side of the transformer.
'Mountainhead' Is Most-Watched HBO Original Film Since 'Bad Education' - Deadline
2024–10–10[John johnson John Johnson ]
For this case there are devices called Metal oxide varistors (MOV).
At the secondary, it is 1000 times less.)turns ratio). If it gets hit with a 100,000 volt bolt of lightning then the voltage arrestors conduct and clamp the voltage down to line voltage, ( but a small amount leaks down the line). This is the problem.
At one ohm, the resistor has a maximum of 1 watt power.
This is where the MOV conducts again, and dissipated the energy.
There is no harm in having the surge suppressor along with the fuse in the circuit. The fuse will not open up until the current melts the link. This will take time, and in the interim, that jolt will get transmitted into the power supplies.
2024–10–11 [Bobby Sanchez Bobby Sanchez ].
This is the picture of an electronic coil of wire wound around a core of magnetic material.
so, what happens?
Lightning arrestor is a spark-gap device, and can be installed anywhere. What is important, is that the wire is thick enough to withstand the lightning bolt and conduct the energy away from the building.
These are simplified answers to the original question, and does not change anything I wrote above.
OK, this is Mohan Rajaratnam’s definition of a Surge suppressor.
At least they know the answer if they wanted it.
2024–10–14 [Omar Gharbi Omar Gharbi ]
The third is lightning and “how it gets conducted into a home.”
In schematic diagrams this is the symbol for a fuse:
Mohan forgets that a fuse is a one-time device, and needs to be replaced if it is tripped.
[old diagram got deleted by accident]
but I think this circuit , shows a few more pieces.
It’s been three xxx five werks, and there has been no response to my follow on query on his Commment to my answer.
What is lightning?
This is 'the assistant's answer'
A fuse is a non-resetable over current circuit protector.
This one hit behind the barn.
so, the loop of wire then, when put together with another loop reduces the ‘noise’ on a power line.
What does a fuse do?
So combined with a device called a MOV or Metal-oxide-resistor, then forms the 3rd part of a “surge suppressor “.
He then describes Rainy Season and Lightning.
(There is no concept of polarity, in the loop because the current changes direction 100 to 120 times a second (power frequency).
Now when you have a certain ac resistance, then a current flows in a loop.
One
2024–10–11 [Victor Olarewsju Victor Olarewaju ]
Fuses, on their own, then operate much slower than the MOV variable resistance, during the lightning strike.
Can the fuse protect the electronic devices from lightning instead of a surge protector.
but this device (an Inductor) … impedes the rapid changes in the current.
But it can get overloaded, and no longer works.
An AC voltage/ current source, and an ac inductive load.
2024–10–16 [ OO OLAOYE OYEBODE ]
Barnstars:
I post the exact comment here.
And this is the problem alone. Is the power supply in the equipmemt designed with a lightning strike in mind? Some yes, others, no.
nine
A circuit breaker is similar, but is resettable.
This is where this question deviates from being a 'generic' question, and becomes more specific.
These devices are installed between the “hot” and “neutral” and protective ground.
It also is a device that limits the change in current flow.
a photo is worth a thousand words.
2024–09–27 [ Mohan Rajaratnam Mohan Rajaratnam ] . Thinks you can get free electricity from nothing : Mohan Rajaratnam's answer to Is it possible to generate free electricity at home using a magnet or other low-cost methods? If so, how does it work?
This is a photo where a lightning bolt took out a home's complete mains distribution box, and a lot of electronic gear as well.
This device then solves the entire problem.
[image of Common-mode choke]
Is the question then , "why buy a surge supressor, if the fuse alone protects the electronic circuits from a lightning bolt?".